0x1949 Team - FAZEMRX - MANAGER

Edit File: Kconfig

# SPDX-License-Identifier: GPL-2.0 if NLM_XLP_BOARD || NLM_XLR_BOARD if NLM_XLP_BOARD config DT_XLP_EVP bool "Built-in device tree for XLP EVP boards" default y select BUILTIN_DTB help Add an FDT blob for XLP EVP boards into the kernel. This DTB will be used if the firmware does not pass in a DTB pointer to the kernel. The corresponding DTS file is at arch/mips/netlogic/dts/xlp_evp.dts config DT_XLP_SVP bool "Built-in device tree for XLP SVP boards" default y select BUILTIN_DTB help Add an FDT blob for XLP VP boards into the kernel. This DTB will be used if the firmware does not pass in a DTB pointer to the kernel. The corresponding DTS file is at arch/mips/netlogic/dts/xlp_svp.dts config DT_XLP_FVP bool "Built-in device tree for XLP FVP boards" default y select BUILTIN_DTB help Add an FDT blob for XLP FVP board into the kernel. This DTB will be used if the firmware does not pass in a DTB pointer to the kernel. The corresponding DTS file is at arch/mips/netlogic/dts/xlp_fvp.dts config DT_XLP_GVP bool "Built-in device tree for XLP GVP boards" default y select BUILTIN_DTB help Add an FDT blob for XLP GVP board into the kernel. This DTB will be used if the firmware does not pass in a DTB pointer to the kernel. The corresponding DTS file is at arch/mips/netlogic/dts/xlp_gvp.dts config DT_XLP_RVP bool "Built-in device tree for XLP RVP boards" default y help Add an FDT blob for XLP RVP board into the kernel. This DTB will be used if the firmware does not pass in a DTB pointer to the kernel. The corresponding DTS file is at arch/mips/netlogic/dts/xlp_rvp.dts config NLM_MULTINODE bool "Support for multi-chip boards" depends on NLM_XLP_BOARD default n help Add support for boards with 2 or 4 XLPs connected over ICI. if NLM_MULTINODE choice prompt "Number of XLPs on the board" default NLM_MULTINODE_2 help In the multi-node case, specify the number of SoCs on the board. config NLM_MULTINODE_2 bool "Dual-XLP board" help Support boards with upto two XLPs connected over ICI. config NLM_MULTINODE_4 bool "Quad-XLP board" help Support boards with upto four XLPs connected over ICI. endchoice endif endif config NLM_COMMON bool endif