0x1949 Team - FAZEMRX - MANAGER
Edit File: Kconfig
# SPDX-License-Identifier: GPL-2.0-only # # FDDI network device configuration # config FDDI tristate "FDDI driver support" depends on PCI || EISA || TC help Fiber Distributed Data Interface is a high speed local area network design; essentially a replacement for high speed Ethernet. FDDI can run over copper or fiber. If you are connected to such a network and want a driver for the FDDI card in your computer, say Y here (and then also Y to the driver for your FDDI card, below). Most people will say N. if FDDI config DEFZA tristate "DEC FDDIcontroller 700/700-C (DEFZA-xx) support" depends on FDDI && TC help This is support for the DEC FDDIcontroller 700 (DEFZA-AA, fiber) and 700-C (DEFZA-CA, copper) TURBOchannel network cards which can connect you to a local FDDI network. To compile this driver as a module, choose M here: the module will be called defza. If unsure, say N. config DEFXX tristate "Digital DEFTA/DEFEA/DEFPA adapter support" depends on FDDI && (PCI || EISA || TC) help This is support for the DIGITAL series of TURBOchannel (DEFTA), EISA (DEFEA) and PCI (DEFPA) controllers which can connect you to a local FDDI network. To compile this driver as a module, choose M here: the module will be called defxx. If unsure, say N. config SKFP tristate "SysKonnect FDDI PCI support" depends on FDDI && PCI select BITREVERSE help Say Y here if you have a SysKonnect FDDI PCI adapter. The following adapters are supported by this driver: - SK-5521 (SK-NET FDDI-UP) - SK-5522 (SK-NET FDDI-UP DAS) - SK-5541 (SK-NET FDDI-FP) - SK-5543 (SK-NET FDDI-LP) - SK-5544 (SK-NET FDDI-LP DAS) - SK-5821 (SK-NET FDDI-UP64) - SK-5822 (SK-NET FDDI-UP64 DAS) - SK-5841 (SK-NET FDDI-FP64) - SK-5843 (SK-NET FDDI-LP64) - SK-5844 (SK-NET FDDI-LP64 DAS) - Netelligent 100 FDDI DAS Fibre SC - Netelligent 100 FDDI SAS Fibre SC - Netelligent 100 FDDI DAS UTP - Netelligent 100 FDDI SAS UTP - Netelligent 100 FDDI SAS Fibre MIC Read <file:Documentation/networking/device_drivers/fddi/skfp.rst> for information about the driver. Questions concerning this driver can be addressed to: <linux@syskonnect.de> To compile this driver as a module, choose M here: the module will be called skfp. This is recommended. endif # FDDI